Machine Administration Guide 2.6

3.1.3 When to Make Settings

Machine Administration supports three types of settings. The first type of settings are made when the main unit is installed. The second type of settings are made when the main unit is in operation. The third type of settings are made as required.

The tables below show settings to be made and the persons in charge responsible for making these settings.

The meanings of symbols in the "Person in charge" column are as follows.

Y: The customer engineer or system administrator makes the appropriate setting.
-: Other persons in charge make the appropriate setting.

When to make the setting				Person in charge
		Contents of the setting	Reference destination	Customer engineer	System administrator
At installation of the main unit
		Monitoring battery life (*1)	3.2.6.1 Monitoring battery life	Y	-
		Setting Monitoring Notification Information	3.1.6.10 Setting Monitoring Notification Information	-	Y
		Set Schedule	3.1.9.2 Set Schedule	-	Y
		Setting Power Recovery Mode	3.1.9.4 Setting Power Recovery Mode	-	Y
		Setting the External Equipment Wait Time	3.1.10.5 Setting the External Equipment Wait Time	-	Y
		Remote Customer Support System (REMCS) Setup Menu	3.1.14 Remote Customer Support System (REMCS) Setup Menu	-	Y
When the main unit is in operation
	When an error occurs/ when a part is replaced	Fan Monitoring	3.1.6.2 Fan Monitoring	-	Y
		Disk Monitoring	3.1.6.3 Disk Monitoring	-	Y
		CPU Monitoring	3.1.6.5 CPU Monitoring	-	Y
		Memory Monitoring	3.1.6.6 Memory Monitoring	-	Y
	When an error occurs	Tape Unit Monitoring	3.1.6.4 Tape Unit Monitoring	-	Y
		Power Supply Unit Monitoring	3.1.6.7 Power Supply Unit Monitoring	-	Y
		UPS Monitoring	3.1.6.8 UPS Monitoring	-	Y
		Degradation Monitoring (*2)	3.1.6.9 Degradation Monitoring	-	Y
	As required	Setting Management Server Logging	3.1.15 Setting Management Server Logging	-	Y
		Hardware Information Display Settings	3.1.16 Hardware Information Display Settings	-	Y
		Matching of Cluster Information	3.1.9.5 Matching of Cluster Information	-	Y
When the main unit is in operation
	As required	Reconfiguring The RCI Network	3.1.10.3 Reconfiguring The RCI Network	-	Y
		Setting the RCI host address	3.1.10.4 Setting The RCI Host Address	-	Y
		Setting Up and Testing the AP-Net	3.1.11 Setting Up and Testing the AP-Net	-	Y

*1 Make this setting not only when installing the main unit but also when performing preventive swapping.

*2 Degradation Monitoring must be set up if an error is detected during initialization.