PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment) |
Contents
![]() ![]() |
Chapter 6 Command Reference | > 6.3 Multipath Control Command |
This section explains subcommands of the iompadm command.
The subcommand and the outline of functions are listed in "Table 6.2 Subcommand List."
[Table 6.2 Subcommand List]
Subcommand
Description
info
Configuration information in the specified interface or in all interfaces, and the status of the communication path are displayed.
status
The status of the specified communication path is displayed.
ident
The class list of the specified communication path is displayed.
probe
The interface to which the specified communication path belongs is displayed.
recover
The specified communication path is restored.
start
The specified communication path is changed to the path that can be communicable after the recover command is issued.
stop
The communication path in the "active" state or the "standby" state is switched to the "stop" state.
active
The communication path in the "standby" state is switched to the "active" state.
add
Adds to the specified interface the specified communication path. The communication path after an addition will be in the "stop" state.
del
Delete the communication path in the "stop" state from the specified interface.
disconnect
The communication path in the "stop" state or the "fail" state is switched to the "disconnected" state.
connect
The communication path of the specified "disconnected" state is switched to "stop" state.
version
Version information of this product is displayed.
help
Help information of specified command is displayed.
Contents
![]() ![]() |