PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment) |
Contents
![]() ![]() |
Chapter 6 Command Reference | > 6.3 Multipath Control Command | > 6.3.2 iompadm subcommands |
The communication path in the "active" state or the "standby" state of the specified interface is switched to the "stop" state.
/usr/opt/FJSViomp/bin/iompadm -c mpnet stop interface_name [communication_path_name]
This subcommand is used when changing the communication path in "active" state or "standby" state into "stop" state.
When this subcommand is processed successfully, the communication path is put into "stop" state.
When the communication path name is specified, this subcommand is processed for the specified communication path.
When this subcommand is processed for a communication path, the communication path in "active" state is put into "stop" state, and the communication path in "standby" state is put into "active" state.
![]()
- When stopping the communication path of "active" state and the communication path of "standby" state does not exist, or when omitting the communication path name and stopping all communication paths, communication stops.
Contents
![]() ![]() |