PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment) |
Contents
![]() ![]() |
Chapter 6 Command Reference | > 6.3 Multipath Control Command | > 6.3.2 iompadm subcommands |
The communication path is switched, and it changes from the "standby" state to the "active" state.
/usr/opt/FJSViomp/bin/iompadm -c mpnet active interface_name communication_path_name
When "standby" state's communication path is specified, the path switch is done from the "active" state's communication path. In addition, the communication path that was the "active" state is changed to the "standby" state.
This subcommand is available for the communication path in "standby" state, and can be used also for the switching back of the communication path.
When this subcommand is processed successfully, the specified communication path is put into "active" status, and the "active" communication path is put into "standby" status.
![]()
- When you use the multiple interfaces of the ATM, and the communication path is switched by this subcommand. The communication path in other interfaces should switch the communication path by this subcommand.
Contents
![]() ![]() |