PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment)
Contents PreviousNext

Chapter 6 Command Reference> 6.3 Multipath Control Command> 6.3.2 iompadm subcommands

6.3.2.12 connect subcommand

Capabilities

The communication path in the "disconnected" state is switched to the "stop" state.

Synopsis

/usr/opt/FJSViomp/bin/iompadm -c mpnet connect interface_name communication_path_name

Description

This subcommand will switch the specified communication path to the "stop" state, if the specified communication path is in the "disconnected" state. If the communication path is not "disconnected" state, the iompadm command will be ended without changing anything.
This subcommand is used when incorporating the device, which was replace a PCI card in "disconnected" state, by disconnect subcommand. Please refer to "8.2 PCI Hot Plug function" about the PCI Hot Plug function.

Contents PreviousNext

All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005