PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment)
Contents PreviousNext

Chapter 6 Command Reference> 6.3 Multipath Control Command> 6.3.2 iompadm subcommands

6.3.2.11 disconnect subcommand

Capabilities

The communication path in the "stop" state or the "fail" state is switched to the "disconnected" state.

Synopsis

/usr/opt/FJSViomp/bin/iompadm -c mpnet disconnect interface_name communication_path_name

Description

This subcommand will switch the specified communication path to the "disconnected" state, if the specified communication path is in the "stop" state or the "fail" state. If the communication path is in any other state, this subcommand will be ended in an error.
The communication path, which has become "disconnected" state by this subcommand, can replace a PCI card by PCI Hot Plug function. Please refer to "8.2 PCI Hot Plug function" about the PCI Hot Plug function.

Contents PreviousNext

All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005