To change the configuration of a cluster application, you must first delete the cluster application. The procedure is shown below.
Operation flow
Operation Procedure:
Stop RMS.
If RMS is running, see "7.2.1.2 Stopping RMS" and stop RMS.
Delete the cluster application.
Delete only the target cluster application.
For details on how to make this deletion, see "8.9.1 Deleting a userApplication."
Note
Do not delete a resource that is necessary to configure the cluster application.
Add, delete, or change the resource.
Add a new resource and delete any unnecessary resources.
See
For details on how to perform the above operations, see the following:
When a resource is to be added: 6.7.1 Setting Up Resources
When a resource is to be deleted: 8.9.2 Deleting a Resource
When a resource is to be changed: 8.1.3 Changing Resources
Note
If you have changed a resource, check that all resources are registered to the cluster application. If there are resources that are not registered to the cluster application, delete them or add them to the cluster application.
Create a cluster application.
Create the same cluster application as that deleted in step 2.
For details on how to create the cluster application, see "6.7.2 Creating Cluster Applications." If cluster application dependency relationships have been set up, they must be set up again.
For details on how to make these settings, see "6.7.3 Setting Up Dependency Relationships Between Cluster Applications."
Note
If it is not necessary to change the operation attributes of the cluster application, leave the attribute unchanged as explained in the "A.9 Cluster Application Worksheets."
