The procedure for installing the slave server functionality is shown below.
Before installing the slave server functionality, set the previously designed values in bdpp.conf.
See
Refer to "Slave server" under "B.1 bdpp.conf" for information on bdpp.conf.
Follow the procedures below to install the slave server functionality.
Set the "BDPP_CONF_PATH" environment variable.
In the "BDPP_CONF_PATH" environment variable, set the directory where bdpp.conf is stored.
Example
If bdpp.conf is stored in /home/data/slaves:
# export BDPP_CONF_PATH=/home/data/slave <Enter>
Mount the DVD-ROM.
Place the DVD-ROM in the DVD drive, then execute the command below to mount the DVD-ROM. If the DVD-ROM is automatically mounted by the automatic mount daemon (autofs), installer startup will fail because "noexec" is set in the mount options.
# mount /dev/hdc dvdRomMountPoint <Enter>
Start the installer.
Execute bdpp_inst to start the installer.
# dvdRomMountPoint/bdpp_inst <Enter>
Select "2. Slave Server installation".
================================================================================
Interstage Big Data Parallel Processing Server
V1.0.1
All Rights Reserved, Copyright(c) FUJITSU LIMITED 2012
================================================================================
<< Menu >>
1. Master Server installation
2. Slave Server installation
3. Development Server installation
4. Collaboration Server installation
================================================================================
Please select number to start specified Server installation [?,q]
=> 2 <Enter>After installation is completed, restart the system.
# shutdown -r now <Enter>
Note
If installation fails, refer to the messages output during the installation operation and/or installation log file (/var/tmp/bdpp_install.log) to diagnose the failure. Then, remove the cause of the failure and perform installation again.
After installing the slave server functionality, apply the updates for this product and the updates for software included with this product.
Refer to the note in "Chapter 6 Installation" for details.