Machine Administration Guide 2.6

B.2.3.3 Mounting a disk that has been hot-swapped after unmounting by means other than GDS

This section describes how to mount a disk that has been hot-swapped after unmounting by a method other than the GDS automatic unmount function.

After completion of replacement using the hot swap menu, you have to perform one of the following operations.

• When using SynfinityDisk/GDS
  You have to perform the operation for mounting disks in SynfinityDisk/GDS.
  Use the sdxswap command or GUI to mount disks in SynfinityDisk/GDS. For the sdxswap command arguments, specify the class name used by SynfinityDisk/GDS and the SDX disk name.

  # /usr/sbin/sdxswap -I -c <class name> -d <SDX disk name>

• When using volume management software other than SynfinityDisk/GDS
  You have to perform the operation for mounting disks in the management scope of the volume management software used.
  For information on how to mount disks, refer to the manual for the relevant volume management software.