Machine Administration Guide 2.6

3.3.3 When to Make Settings

Machine Administration supports three types of settings. The first type of settings are made when the main unit is installed. The second type of settings are made when the main unit is in operation. The third type of settings are made as required.

The tables below show settings to be made and the persons in charge responsible for making these settings.

The meanings of symbols in the "Person in charge" column are as follows.

Y: The customer engineer or system administrator makes the appropriate setting.
-: Other persons in charge make the appropriate setting.

When to make the setting				Person in charge
		Contents of the setting	Reference destination	Customer engineer	System administrator
At installation of the main unit
		Monitoring battery life (*1)	3.3.6.1 Monitoring battery life	Y	-
		Setting Monitoring Notification Information	3.3.6.4 Setting Monitoring Notification Information	-	Y
		Add Schedule Entry	3.3.9.3 Add Schedule Entry	-	Y
		Add Holiday	3.3.9.4 Add Holiday	-	Y
		Warm-up Time Administration	3.3.12.2 Warm-up Time Administration	-	Y
		Setting the External Equipment Wait Time	3.3.10.5 Setting the External Equipment Wait Time	-	Y
		Setting waiting time for shutdown at power failure	3.3.11.1 Setting waiting time for shutdown at power failure	-	Y
		Remote Customer Support System (REMCS) Setup Menu	3.3.15 Remote Customer Support System (REMCS) Setup Menu	-	Y
When the main unit is in operation
	When an error occurs/when a part is replaced	Disk Monitoring	3.3.6.2 Disk Monitoring	-	Y
	When an error is occured	Tape Unit Monitoring	3.3.6.3 Tape Unit Monitoring	-	Y
	As required	Add Schedule Entry	3.3.9.3 Add Schedule Entry	-	Y
		Add Holiday	3.3.9.4 Add Holiday	-	Y
		Reconfiguring The RCI Network	3.3.10.3 Reconfiguring The RCI Network	-	Y
		Initial RCI Network Setup	3.3.10.4 Initial RCI Network Setup	-	Y
		Setting Up and Testing the AP-Net	3.3.12 Setting Up and Testing the AP-Net	-	Y
		HCP File Operation	3.3.13.1 HCP File Operation	-	Y

*1 Make this setting not only when installing the main unit but also when performing preventive swapping.