Machine Administration Guide 2.6
Contents Index PreviousNext
Chapter 3 Model Family-Specific Information> 3.3 PRIMEPOWER650/850/900/1500/2500/HPC2500> 3.3.14 Firmware Administration

3.3.14.1 HCP File Operation

For PRIMEPOWER900/1500/2500/HPC2500 models, this function is not supported.

The following describes how to perform Hardware Control Program (HCP) Administration.

The following operation should only be performed by a certified service engineer.

Using Display of Hardware Control Program (HCP) Image(s) Stored in the Machine Administration Program

Operation

  1. From the Hardware Control Program (HCP) Administration menu, select [Display of Hardware Control Program (HCP) Image(s) Stored in the Machine Administration Program].

    A list of the registered firmware appears.

  2. To delete firmware, select the firmware to be deleted from the list and perform the required operations according to the menu.

    The selected firmware is deleted.

Hardware Control Program (HCP) Image Administration

Operation

  1. From the Hardware Control Program (HCP) Administration menu, select [Hardware Control Program (HCP) Image Administration].

    Information about firmware stored on the HCP CD-ROM or in the working directory appears.

  2. Select the firmware to be registered from the list and perform the required operations according to the menu.

    The selected firmware is registered.

Contents Index PreviousNext
All Rights Reserved, Copyright(C) FUJITSU LIMITED 2001-2005
All Rights Reserved, Copyright (C) PFU LIMITED 2001-2005