PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment)
Contents PreviousNext

Chapter 7 Administration on a Cluster System> 7.2 The environmental configuration on PRIMECLUSTER> 7.2.1 Adding the Cluster Environmental Configuration

7.2.1.1 Environmental Configuration

For the Multipath function to work properly, common environmental configuration must be performed.
Refer to "Chapter 3 Configuration" for detailed information about configuration.
Be sure to perform the environmental configuration in each node.
There are two configuration methods: Set the environmental configuration in each node, or using "copy" (mpnet_copyfile) command to perform the environmental configuration.
When the environmental configuration is performed for each node without the "copy" (mpnet_copyfile) command, the configuration in the interface should have same information between nodes.
The "copy" (mpnet_copyfile) command is recommended on the target node of which the hardware configuration and LAN device configuration are the same.
For details about the "copy" (mpnet_copyfile) command, see "Chapter 6 Command Reference."

Contents PreviousNext

All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005