PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment) |
Contents
![]() ![]() |
Chapter 7 Administration on a Cluster System | > 7.2 The environmental configuration on PRIMECLUSTER |
In the Multipath function, resource registration is required as well as the usual environmental configuration.
"Figure 7.4 Flow of an Additional Procedure of Cluster Environmental Configuration" shows how to perform the additional procedure of the configuration by using the "userApplication Configuration wizard." The registration of a resource is the same procedure even when using "RMS wizards." Please refer to "PRIMECLUSTER Installation and Administration Guide", or "PRIMECLUSTER Relient Monitor Services (RMS) Configuration and Administration Guide" about the details of the configuration method of the userApplication using "RMS Wizards."
[Figure 7.4 Flow of an Additional Procedure of Cluster Environmental Configuration]
The command shown in "Table 7.1 Cluster Configuration Operation Command" can be used to perform the cluster environmental configuration.
This command can only be execute in the clustering system environment.
[Table 7.1 Cluster Configuration Operation Command]
Type
Command
Description
Permission
resource registration / deletion
/opt/FJSVmpnet/cluster/bin/mpnet_addrid
resources are registered
Super-user
/opt/FJSVmpnet/cluster/bin/mpnet_delrid
resources are deleted.
Super-user
/opt/FJSVmpnet/cluster/bin/mpnet_rid
The resources of all nodes or specified nodes are registered or deleted.
Super-user
copy of environmental configuration
/opt/FJSVmpnet/cluster/bin/mpnet_copyfile
Environmental configuration is copied into all nodes or the specified node.
Super-user
Contents
![]() ![]() |