| PRIMECLUSTER Installation and Administration Guide 4.1 (for Solaris(TM) Operating System) |
|
Contents
Index
|
| Part 2 Installation | > Chapter 4 Preparation Prior to Building a Cluster | > 4.3 Preparations for Starting the Web-Based Admin View Screen | > 4.3.3 Initial Setup of Web-Based Admin View |
This section describes the procedure for confirming whether Web-Based Admin View has been started.
Confirmation ProcedureCheck that all node information is output by executing the "wvstat(1M)" command on the connected management server.
[Example]
In a two-node configuration consisting of node1(10.20.30.40) and node2(10.20.30.41), node1 is the primary management server and node2 is the secondary management server.
# /etc/opt/FJSVwvbs/etc/bin/wvstat
primaryServer 10.20.30.40 node1 http=10.20.30.40 Run 1d+7h36m
primaryServer Sessions: 0
primaryServer Nodes: 2
10.20.30.40 node1 SunOS-5.8 1d+7h36m
10.20.30.41 node2 SunOS-5.8 1d+7h36m
secondaryServer 10.20.30.41 node2 http=10.20.30.41 Run 1d+7h36m
secondaryServer Sessions: 0
secondaryServer Nodes: 2
10.20.30.41 node2 SunOS-5.8 1d+7h36m
10.20.30.40 node1 SunOS-5.8 1d+7h36m
#
If the information is not properly displayed, Web-Based Admin View has not been started or there may be an error in the Web-Based Admin View settings. Restart Web-Based Admin View and execute the operation again. If node information is still not displayed, refer to the "PRIMECLUSTER Web-Based Admin View Operation Guide" and check the parameter settings.
For details on the wvstat(1M) command, see the manual page.
|
Contents
Index
|