PRIMECLUSTER Installation and Administration Guide 4.1 (for Solaris(TM) Operating System)

4.3.3.1 Initial setup of the operation management server

When using Web-Based Admin View for the first time, you need to initialize the management server on each node. Take the following steps in the order listed below.

You do not have to initialize the server on the node on which PRIMECLUSTER was installed using the One Shot Installer tool

Operation Procedure:

1. Stop Web-Based Admin View on all the management servers and nodes.

   # /etc/init.d/fjsvwvcnf stop

   # /etc/init.d/fjsvwvbs stop

2. Set the IP addresses of the primary management server and secondary management server.
   Execute the following command on all the management servers and nodes, referring to the example.

   # /etc/opt/FJSVwvbs/etc/bin/wvSetparam primary-server <primary-management-server-IP-address>

   # /etc/opt/FJSVwvbs/etc/bin/wvSetparam secondary-server <secondary-management-server-IP-address>

   Example: Set the "primary management server IP" and "secondary management server IP" of the "operation management mode" found on the cluster building worksheet.

   # /etc/opt/FJSVwvbs/etc/bin/wvSetparam primary-server 10.34.214.181

   # /etc/opt/FJSVwvbs/etc/bin/wvSetparam secondary-server 10.34.214.182

3. Restart Web-Based Admin View on all the management servers and nodes.

   # /etc/opt/FJSVwvbs/etc/bin/wvCntl restart

   # /etc/init.d/fjsvwvcnf start

Web-Based Admin View has some different operation management modes. For further details, see "1.2.2 System topology" and "Chapter 7 Web-Based Admin View setup modification" in the "PRIMECLUSTER Web-Based Admin View Operation Guide."