The following is a description of the procedure for operations performed when the Storage Cluster Controller is in use.
Add and delete a monitored device.
Change the IP address of a monitored device.
Add and delete a monitored device in the following steps:
Editing TFOConfig.ini File
Edit the TFOConfig.ini file as follows:
Add a monitored device
Add the information for a monitored ETERNUS Disk storage system.
Delete a monitored device
Delete the information for an ETERNUS Disk storage system excluded from monitored targets.
Refer to "A.12 TFOConfig.ini Parameter" for the editing method.
Restarting Agent
To reflect settings, restart agent.
Checking Monitored Status
Use the agtpatrol command to check the status of a monitored ETERNUS Disk storage system. Check the following matters:
When adding:
The entry of an added ETERNUS Disk storage system is displayed in the command execution result.
When deleting:
The entry of a deleted ETERNUS Disk storage system is not displayed in the command execution result.
Change the IP address of a monitored device in the following steps:
Changing IP Address
Change the IP address of monitored devices.
Editing TFOConfig.ini File
Edit the TFOConfig.ini file as follows:
Delete pre-change ETERNUS Disk storage system information.
Add post-change ETERNUS Disk storage system information.
Refer to "A.12 TFOConfig.ini Parameter" for the editing method.
Restarting Agent
To reflect settings, restart agent.
Check Monitored Status
Use the agtpatrol command to check the status of a monitored ETERNUS Disk storage system. Check the following matters:
The entry of pre-IP address changed ETERNUS Disk storage system is not displayed in the command execution result.
The entry of post-IP address changed ETERNUS Disk storage system is displayed in the command execution result.
