This section describes the initial cluster setup for PRIMECLUSTER.
If the virtual machine function is used, you need to set up a virtual network first.
For details, refer to "PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function" or the Linux documentation.
For details on the setup methods, see the reference locations indicated in the table below.
Contents | Manual reference location* | |
|---|---|---|
1 | 5.1.1 Setting Up CF and CIP (setting up cluster configuration information and IP addresses) | CF "1.1 CF, CIP, and CIM configuration" |
2 | CF "7 Shutdown Facility" | |
3 | 5.1.3 Initial Setup of the Cluster Resource Management Facility | CF "3.1 Resource Database configuration" |
* The PRIMECLUSTER manual names are abbreviated as follows:
CF: PRIMECLUSTER Cluster Foundation (CF) Configuration and Administration Guide
Note
When Firewall is enabled, disable it before the initial cluster setup.
When enabling Firewall after completing the installation of the cluster, see "Appendix K Using Firewall."
