PRIMECLUSTER Installation and Administration Guide 4.4

Chapter 5 Building a Cluster

The procedure for building a PRIMECLUSTER cluster is shown below:

Table 5.1 Cluster building procedure and manual reference locations

	Work item	Execution Node	Required/Optional	Manual reference location*1
(1)	5.1.1 Setting Up CF and CIP	All nodes	Required	CF "1.1 CF, CIP, and CIM configuration"
	5.1.2 Setting up the Shutdown Facility	All nodes	Required*2	CF "7 Shutdown Facility "
	5.1.3 Initial Setup of the Cluster Resource Management Facility	All nodes	Required	CF "3.1 Resource Database configuration"
(2)	5.2 Setting Up Fault Resource Identification and Operator Intervention Request	1 node	Required

*1 The PRIMECLUSTER manual names are abbreviated as follows:

• CF: PRIMECLUSTER Cluster Foundation (CF) Configuration and Administration Guide

*2 When configuring a single node cluster, it is not necessary to setup the shutdown facility.

Note

• Execute the configuration setting of GDS after initializing the cluster.

• If you deactivate the virtual interfaces such as GLS, tagged VLAN, and virtual bridge, or restart the network service before setting CF and CIP, restart CF first, and then start the settings of CF and CIP.
  For information on how to stop and start CF, see "4.6 Starting and stopping CF" in "PRIMECLUSTER Cluster Foundation (CF) Configuration and Administration Guide."