After completing the design of the PRIMECLUSTER system and determining the configuration of the PRIMECLUSTER system to be built, install the PRIMECLUSTER system.
Since the work will be performed based on PRIMECLUSTER Designsheets that were created, check that all items on PRIMECLUSTER Designsheets have been entered.
Information
PRIMECLUSTER Designsheets are stored in documents/designsheet in PRIMECLUSTER DVD.
Install the PRIMECLUSTER system by performing the following procedure in sequence from (1).
Perform the operations described in the dotted line sections if the system design matches the described conditions.
If you are installing applications after you install the PRIMECLUSTER system, go back to the operations from the Application environment setup to the Application installation.
The screens to be used differ according to the operation. The work procedures to be performed with GUI from Web-Based Admin View and the work procedures to be performed with CLI and CUI from console screens are shown in separate boxes.
Figure 1.2 Flow of PRIMECLUSTER system installation
The abbreviations in the flowchart for PRIMECLUSTER system installation are explained below.
CF: Cluster Foundation
RMS: Reliant Monitor Services
WT: Wizard Tools
GDS: Global Disk Services
GFS: Global File Services
GLS: Global Link Services
For detailed information on each item, refer as necessary to the corresponding manual reference section mentioned in the table below.
GLS: Global Link Services
GDS: Global Disk Services
GFS: Global File Services
