ILOM shutdown agent is the shutdown agent for SPARC Enterprise T5120, T5220, T5140, T5240, T5440 series, and SPARC T3, T4, T5, T7, S7 series.
Setup and configuration
The ILOM must be configured according to the directions below:
For ILOM 2.x
Integrated Lights Out Manager User's Guide
For ILOM 3.0
Integrated Lights Out Manager (ILOM) 3.0 Concepts Guide
Integrated Lights Out Manager (ILOM) 3.0 Web Interface Procedures Guide
Integrated Lights Out Manager (ILOM) 3.0 CLI Procedures Guide
Integrated Lights Out Manager (ILOM) 3.0 Getting Started Guide
Moreover, you must set the user name and password to allow the operation in ILOM.
When using ILOM, check the configuration of ILOM by referring to "5.1.2.3.1 Checking Console Configuration" of the "PRIMECLUSTER Installation and Administration Guide."
Shutdown Agent
There are two kinds of ILOM SAs:
SA_ilomp-panics the node through ILOM.
SA_ilomr-resets the node through ILOM.
The ILOM log file is as follows:
/var/opt/SMAWsf/log/SA_ilomp.log /var/opt/SMAWsf/log/SA_ilomr.log
Note
The IP address of ILOM belongs to the same segment as the Administrative LAN.
However, if the network routing is configured, the IP address of ILOM does not need to belong to the same segment as the Administrative LAN of the cluster node.
If ILOM is used for the console, the No.7040 error message might appear on the other nodes in the following cases:
Turning off a node for maintenance
Changing the network configuration of ILOM
Updating the ILOM firmware
If the error message is displayed, take corrective action of the No.7040 error message after each operation is completed.
After Shutdown Facility (SF) startup, it can take up to 30 seconds to detect hardware failures such as ILOM errors or a disconnected cable, and setting errors like incorrect IP addresses.
