ALOM SA is the Shutdown Agent for SPARC Enterprise T1000, T2000.
Setup and configuration
The ALOM must be configured according to the directions in the "Advanced Lights out Management (ALOM) CMT guide."
Moreover, you must set the user name and password to allow the operation in ALOM.
When using ALOM, check the configuration of ALOM by referring to "5.1.2.4.1 Checking Console Configuration" of the "PRIMECLUSTER Installation and Administration Guide."
Shutdown Agent
SA_sunF-sends a control break signal to the node through ALOM.
The ALOM log file is as follows:
/var/opt/SMAWsf/log/SA_sunF.log
Note
The IP address of ALOM belongs to the same segment as the Administrative LAN.
However, if the network routing is configured, the IP address of ALOM does not need to belong to the same segment as the Administrative LAN of the cluster node.
After Shutdown Facility (SF) startup, it can take up to 50 seconds to detect hardware failures such as ALOM errors or a disconnected cable, and setting errors like incorrect IP addresses.
