Install to physical environment
The method of installation using a master PC in the physical environment is as follows. For an overview of the installation method, refer to "1.2.5 Determine How to Install Client (CT)".
Remove the LAN Cable of the PC being used as the master PC.
Do not connect the LAN Cable before the following Step 3. is completed.
Install the client (CT).
For installation method, refer to single installation "2.6.1.1 Wizard-style Installation" or "2.6.1.2 Perform Silent Installation".
Create the master image with image creation software.
Distribute images of the client (CT) to each PC to which the client (CT) is installed.
Start the PC where the client (CT) was distributed to, and confirm the content registered to the Management Server.
(Next, execute when managing the terminal as master PC on the Systemwalker Desktop Keeper Management Server.)
Connect the LAN Cable of the master PC and restart Windows.
Confirm the content of the master PC registered to the Management Server.
Note
Notes for creating master PC
When creating the client (CT) image and installing the client (CT), it is necessary to install the client (CT) and create the image when the Management Server is not connected to network. (When creating the image and extracting to other PCs under the status that communication with Management Server has been performed only once, be aware that the PC will be registered to the server by mistake.)
In addition, be aware that the structures of image creation source terminal and decompression target terminal are the same. When installing the drive connected with a USB (such as the CD Drive) when creating the image, an error message will be displayed in the event log of the decompression target terminal.
Installation under virtual environment
The method to install a client (CT) in the virtual environment is as follows. For an overview of the installation method, refer to "1.2.5 Determine How to Install Client (CT)".
Install the client (CT) in the master image of the virtual environment.
For installation method, refer to single installation "2.6.1.1 Wizard-style Installation" or "2.6.1.2 Perform Silent Installation".
Make sure to restart after installation.
Log on to the master image of the virtual environment with administrator's authority.
Start the Management Console and confirm the client (CT) installed in the master image has been registered.
Start the command prompt in the master image of the virtual environment, and execute the following command.
fsw11ej7.exe [password] /image provisioning
Save the master image using the functions of the virtual environment.
