PRIMECLUSTER Installation and Administration Guide4.3

6.7 Setting Up Cluster Applications

This section explains how to set up a cluster application by using the cluster application GUI.

The terms "userApplication" and "Resource" that appear on the setup screen refer to "cluster application" and "resource" respectively.

Information

• After you finish setting up the cluster application, start the cluster applications. For instructions on starting the application, see "7.2.2.1 Starting a Cluster Application."

• For instructions on changing a cluster application, see "8.1 Changing the Cluster Configuration." For instructions on deleting a cluster application, see "8.9 Deleting a Cluster Application."

Note

• Set up the cluster application and resources based on the cluster application and resource information in the "A.9 Cluster Application Worksheets," which was created in the planning stage. If you need to change the cluster application after it is created, the worksheet is helpful.

• You cannot share one resource with multiple userApplication.

• If there are files with the same name as shown below on setup of a cluster application, you cannot set up a cluster application properly. If files with the same name exist, delete them before setting up a cluster application.

  • /tmp/hostcheck

  • /tmp/sdxinfo

  • /tmp/work

  • /tmp/workc

  • /tmp/workn

  • /tmp/macaddr

  • /tmp/wgcnf000.tmp

  • /tmp/wgcnf001.tmp

  • /tmp/wgcnf002.tmp

  • /tmp/wgcnf003.tmp

• If you use userApplication Configuration Wizard, the CF remote services (remote file copy and remove command execution) are enabled automatically. For instructions on disabling these definitions, see Notes in "5.1.1 Setting Up CF and CIP."

• If you click <Registration> on the confirm registration screen for userApplication or Resource, the dialog boxes will appear (0805 followed by 0813) to show the status of the configuration process. While these dialog boxes are displayed, do not operate the userApplication Configuration Wizard screen, which is on the background.

• The RMS configuration created in the userApplication Configuration Wizard cannot be used in the RMS Wizard. Moreover, the RMS configuration created in the RMS Wizard cannot be used in the userApplication Configuration Wizard.

Setting up cluster applications by using GUIs

Operation Procedure:

1. Resource setup

   Create all resources that make up the userApplication.

2. userApplication setup

   Use all the resources and create the userApplication.

   Note

   • RMS will not start if there is any remaining resource that is not part of userApplication. Delete unnecessary resources.

   • To create multiple userApplication, repeat steps 1) and 2).

3. Dependency relationship settings for userApplication

   Dependency relationship settings are enabled when two or more userApplication are created.

   These settings define how each userApplication is controlled on the same cluster node.

Starting the userApplication Configuration Wizard

1. At the Web-Based Admin View top screen, select Global Cluster Services.

2. At the Global Cluster Services screen, select userApplication Configuration Wizard.

Explanation of GUI screen and icons

The userApplication Configuration Wizard screen has the configuration shown below.

The following table shows the icons that are displayed in the tree view of the userApplication Configuration Wizard.

Icon	Description
	Indicates the configuration.
	Indicates that a discrepancy was found in the configuration information. A resource that does not belong to any userApplication or userApplication with no resources was found.
	Indicates SysNode.
	Indicates userApplication.
	Indicates userApplication that was created with the TURNKEY Wizard. The userApplication Configuration Wizard does not allow change and deletion operations for this userApplication and its Resources.
	Indicates a controller.
	Indicates a resource.