Applicable versions and levels
Windows versions: V5.0L10 or later
Solaris versions: 5.0 or later
Linux versions: 5.2, V10.0L10 or later
Linux for Itanium versions: V12.0L10 or later
HP-UX versions: 5.1 or later
AIX versions: 5.1 or later
DS versions: V20L10
Action
Points to check
Was the information related to the startup day changed (on the Startup Days/Calendar/Operation period tab) in the Job Net Properties window?
Cause
If the following tabs are changed in the Job Net Properties window, Jobscheduler will create the startup day again according to the settings on each tab:
The Startup days tab
The Calendar tab (V13.3.1 or earlier)
The Operation period tab (V13.3.1 or earlier)
For this reason, the startup day information (exception day) set in the Startup Days window or the Application Plan window will be cleared.
Additionally, if the job net control statement, in which the following operands are specified, is used to execute the jobschsetnet -nche command, the startup day will also be created again, so the startup day information (exception day) will be cleared.
If the following operands marked with an asterisk are specified, the startup day is created again only if you specify an operand value that differs from the value before the change.
execpattern (*)
execpatmode (*)
basenet (*)
annualydate
annualyweek
monthlydate
monthlyweek
bnsmode (*)
bnsbase (*)
bnsday
bnslimit (*)
offsetmode
offsetday
offsetholiday (*)
holidaycalendar (*)
holidaymode
holidayshift (*)
shiftlimit
enablestart
enableend
disablestart
disableend
Action method
To reset the startup day that was cleared, set the startup day information individually in the Startup Days window or Application Plan window of the job net.
