The procedure to edit parameter information is as follows:
In the Parameter tab, select the parameter information to be edited.
Point
The parameter information will be displayed in tree format below the software setup information.
When the [
] button before the software setup information is clicked, the parameter information that was added will be displayed.
Click the Edit button. The Edit parameter window will be displayed.
If the type is "string", an empty string check box will be displayed below the set value at the bottom of the page.
Figure 7.7 Edit parameter window
Edit the parameter information if necessary.
Click the Edit button. A message confirming that the parameter information was edited will be displayed, followed by the updated list in the Parameter tab.
Point
When the parameter information is edited, Included will be displayed in the Change field.
When the parameter is added, all the items that were specified can be edited.
The procedure for the Edit parameter window is the same as that of the Add parameter window.
Refer to "7.3.6 Adding Parameter Information" for details.
