Systemwalker Runbook Automation Installation Guide

3.1 Setting up the Management Server

After Systemwalker Runbook Automation is installed, the Management Server must be set up.

This section describes how to set up the Management Server.

Refer to the Systemwalker Runbook Automation Cluster Setup Guide for information on creating a Systemwalker Runbook Automation cluster environment.

1. Setup Preparation

   Refer to "3.1.2 Setup Preparation".

2. Interstage Single Sign-On Build and Settings

   Refer to "3.1.3 Interstage Single Sign-On Build and Settings".

3. Install in a ServerView Operations Manager Single Sign-On Environment

   Refer to "3.1.4 Installing in a ServerView Operations Manager Single Sign-On Environment".

4. LDAP Environment Build and Settings

   Refer to "3.1.5 LDAP Environment Build and Settings".

5. Register Users, Groups and Organizational Units

   Refer to "3.1.6 Registering Users, Groups and Organizational Units".

6. Set up Systemwalker Runbook Automation

   [Windows]

   Refer to "3.1.7 Setting up Systemwalker Runbook Automation [Windows]".

   [Linux]

   Refer to "3.1.8 Setting up Systemwalker Runbook Automation [Linux]".

7. Settings for Automatically Collecting Configuration Information

   Refer to "3.1.9 Settings for Automatically Collecting Configuration Information".

8. Settings for Using the Operation Component

   Refer to the "3.1.10 Settings for Using the Operation Component".

Note

Refer to "3.1.1 Pre-setup Notes" for information on steps required before setup.