Open the Tamper Monitor URL Entry window as follows:
13.1 Viewing the Environment Settings Window -> 13.1.1 Contents Tampering Monitor window (menu window) -> 13.1.2 Tamper Monitor URL Entry window
To meet the previous example, set data as shown below:
See
Please refer to "13.1.2 Tamper Monitor URL Entry window" about the details of a screen.
Note
The behavior in step 3 of the figure in "10.3 Registering Monitoring Requirements" is performed on the managed server information (the URL for the agent) that matches the host information for the URL set up here.
The host information of the URL specified here should be the same as the host information of the agent URL specified in the managed server information.
If a host name is set in the host component of the agent URL of the managed server, a host name should also be set in the host component of this URL.
If an IP address is specified in the host component of the agent URL of the managed server, an IP address should also be set in the host component of this URL.
Note also that because only one IP address can be specified for a single managed server, in the case of a name-based virtual site, only one virtual site can be monitored using a single IP address.
Make sure that the host information for the URL set up here matches the host information for the URL of the agent in the managed server information. The part of the managed server information that needs to be checked has been circled in red in the screen shot below.
