PRIMECLUSTER GLS for Windows User's Guide 4.3

A.2.2 Configuration with Some NICs Shared by Virtual Adapters Using VLAN Tagging

This is the configuration to use when combining any of the three configurations described above. Those three configurations are:

• Single Virtual Adapter without Shared NICs

• Multiple Virtual Adapters without Shared NICs

• Shared NICs (All NICs Shared by Virtual Adapters Using VLAN Tagging)

Configuration

Figure A.5 Configuration with Some NICs Shared by Virtual Adapters Using VLAN Tagging

Setting Procedure Assuming the Configuration in Figure A.5

1. Set the physical adapter.

   For more details, refer to "3.4.2 Preliminary Tasks: Physical Adapter Settings."

2. Set the virtual adapters.

   Using the hanetconfig command, bundle the physical adapters Local Area Connection 1 and Local Area Connection 2 and create the virtual adapter sha0 with 2 as its VLAN ID. Using the hanetconfig command again, bundle the physical adapters Local Area Connection 1 and Local Area Connection 2 and create the virtual adapter sha1.

   > hanetconfig create -n sha0 -t "Local Area Connection 1","Local Area Connection 2" -v 2
   FJSVhanet: INFO: 00000: The command ended normally.
   > hanetconfig create -n sha1 -t "Local Area Connection 1","Local Area Connection 2"
   FJSVhanet: INFO: 00000: The command ended normally.

3. Set the ping monitor function.

   Execute the hanetpoll command with the following specifications:

   Monitor target when Local Area Connection 1 is operational: 192.168.2.10,192.168.2.20
   Monitor target when Local Area Connection 2 is operational: 192.168.2.10,192.168.2.20

   > hanetpoll create -t "Local Area Connection 1" -p 192.168.2.10,192.168.2.20
   FJSVhanet: INFO: 00000: The command ended normally.
   > hanetpoll create -t "Local Area Connection 2" -p 192.168.2.10,192.168.2.20
   FJSVhanet: INFO: 00000: The command ended normally.

   Information

   By setting a destination system as the ping monitor target, you can specify the switching behavior of adapters if a network error is detected.
   To set so that the network adapter is not switched if an error is detected:

   > hanetpoll create -t "Local Area Connection 1" -p 192.168.2.2 -f no
   FJSVhanet: INFO: 00000: The command ended normally.
   > hanetpoll create -t "Local Area Connection 2" -p 192.168.2.2 -f no
   FJSVhanet: INFO: 00000: The command ended normally.

   For more details, refer to "6.2.4 hanetpoll."

4. Set IP addresses for virtual adapters.

   You can set IP addresses automatically using the adapter setting script provided with GLS. For more details, refer to "3.4.5 Follow-up Tasks: IP Address Settings."

   Note

   In order to set an IP address manually, the virtual adapter must be activated in advance.

5. Activate the virtual adapters.

   Execute the strhanet command and activate the virtual adapters.

   > strhanet
   FJSVhanet: INFO: 00000: The command ended normally (sha0).
   FJSVhanet: INFO: 00000: The command ended normally (sha1).
   FJSVhanet: INFO: 00007: Start the ping monitor using the hanetpoll command if needed.

6. Start the ping monitor function.

   Execute the hanetpoll command.

   > hanetpoll on
   FJSVhanet: INFO: 00000: The command ended normally.