PRIMECLUSTER Wizard for NetWorker 4.2 Configuration and AdministrationGuide

A.1 userApplication Creation(CUI)

This section explains how to setup RMS configurations using by CUI.

Note

RMS configurations by CUI may differ slightly from the one by GUI.

• Standby operation

  A userApplication is configured as follows.

  Create a NetWorker resource after NetWorker is installed.

  

• Scalable operation(Only client cluster operation)

  When you combine N:1 standby or mutual standby with the scalable operation of NetWorker client shown by "1.2.2.3 Client cluster operation ", create the resources except NetWorker and userApplications which include them.

  Create NetWorker resources and the userApplications which include them after NetWorker is installed.

  

Set up userApplication using the RMS Configuration Wizard. The RMS Configuration Wizard uses the format that allows you to select information in the menu.
The following command is executed on any one of the cluster nodes:

# hvw  -n  <Definition name>

This section explains userApplication creation and non-NetWorker resource setup. userApplication is configured with the RMS Configuration Wizard. This RMS Configuration Wizard forms Wizard format.

1. Application-Create

2. Configuration-Generate

3. Configuration-Activate

On Application type selection menu, the menus in capital letters are the turnkey wizards (e. g. NETWORKER) that enables you to create userApplication easily.

The following pages describe procedure for creating the userApplication which includes a NetWorker resource with the turnkey wizard. Create the userApplications which include no NetWorker resource according to the creating procedure of each application.

Information

For further details, see the PRIMECLUSTER manuals.