ServerView Resource Coordinator VE Installation Guide

2.3.3 Installation [Linux]

Install the HBA address rename setup service using the following procedure:

The installation time for this software is around one minute.
Before installing Resource Coordinator VE, check that the preparations given in "2.3.1 Preparations" have been performed.

1. Log in to the system as the OS administrator (root).

   Boot the managed server that Resource Coordinator VE is to be installed on in multi-user mode, and then log in to the system using root.

2. Set the Resource Coordinator VE CD-ROM and execute the following command, then move to the directory where the installer is stored.

   # cd CD-ROM_mount_point/hbaar <RETURN>

3. Execute the HBA address rename setup service installer (the rcxhbainstall command).

   # ./rcxhbainstall <RETURN>
   ServerView Resource Coordinator VE V2.2.0
   
   Copyright FUJITSU LIMITED 2007-2010
   
   This program will install ServerView Resource Coordinator VE HBA address rename setup service on your system.

4. The license agreement is displayed.

   This program is protected by copyright law and international treaties.
   Unauthorized reproduction or distribution of this program, or any portion of it, may result in severe civil and criminal penalties, and will be prosecuted to the maximum extent possible under law.
   
   Copyright FUJITSU LIMITED 2007-2010
   Do you accept the terms of the above License Agreement? [y,n,?,q]

   Check the content of the agreement, and enter "y" if you agree or "n" if you do not agree.

   If "n" or "q" is entered the installation is discontinued.

   If "?" is entered, an explanation of the entry method will be displayed.

5. Enter "y" and the installation will start.

   Example

   INFO : Starting Installation of ServerView Resource Coordinator VE HBA address rename setup service...
   ...
   INFO : Package "FJSVscw-common" was successfully installed.
   ...
   INFO : Package "FJSVrcvhb" was successfully installed.
   ...

6. When installation is completed successfully, the following message will be displayed.

   INFO : ServerView Resource Coordinator VE HBA address rename setup service was installed successfully.

Note

• Corrective Action for Installation Failure

  Execute the following command, delete the packages from the environment in which installation failed, and then perform installation again.

  # cd CD-ROM_mount_point/hbaar <RETURN>
  # ./rcxhbauninstall <RETURN>