This section explains the preparations and checks required before commencing installation.
Software preparation and checks are explained in the following sections.
Exclusive Software Checks
Before installing Resource Coordinator VE, check that the software listed in "1.1.2.3 Exclusive Software" and the HBA address rename setup service of Resource Coordinator VE have not been installed on the system.
Use the following procedure to check that exclusive software has not been installed.
Check if the HBA address rename setup service has been installed using the following procedure:
[Windows]
Open "Add or Remove Programs" from the Windows Control Panel, and check that none of the software listed in "1.1.2.3 Exclusive Software" or the following software are displayed.
"Systemwalker Resource Coordinator Virtual server Edition HBA address rename setup service"
"ServerView Resource Coordinator VE HBA address rename setup service"
Information
For Windows Server 2008 or Windows Vista, select "Programs and Features" from the Windows Control Panel.
[Linux]
Execute the following command and check if the package has been installed.
# rpm -q FJSVrcvhb FJSVscw-common FJSVscw-tftpsv <RETURN> |
If exclusive software has been installed, uninstall it according to the procedure described in the relevant manual before proceeding.
Before installing Resource Coordinator VE, collect required information and check the system status, then determine the information to be specified on the installation window. The information that needs to be prepared is given below.
Installation folder and available disk space
Decide the installation folder for Resource Coordinator VE. Check that the necessary disk space can be secured on the drive for installation.
For the amount of disk space necessary for Resource Coordinator VE, refer to "1.1.2.4 Static Disk Space" and "1.1.2.5 Dynamic Disk Space".
