Phenomenon
On the Client window or storageadm spindle command, the disk drive rotation cannot be stopped even if the "stop request" is executed.
Action
When any message is output by the operation, refer to its message explanation in the "ETERNUS SF Storage Cruiser Message Guide" and solve the problem.
When using the storageadm spindle command, refer to the notes of its command in addition to above. The reference point is as follows.
Solaris OS version : "NOTES" in the "12.1.1.7 Disk control command (storageadm spindle)"
Linux version: "NOTES" in the "12.2.1.7 Disk control command (storageadm spindle)"
Windows version: "NOTES" in the "12.3.1.8 Disk control command (storageadm spindle)"
The disk drive does not stop when the target RAID group status is as follows. Check the RAID group status.
Part of the storage device controller module and the module for the disk drive access route contain a fault.
The disk drive that was used to configure the RAID group is faulty.
There is AdvancedCopy copy data.
There is an EC/REC session (including when there is no copy data). The disk does, however, stop when the EC/REC status is Suspend.
There is a QuickOPC/SnapOPC session (including when there is no copy data).
If the volume that belongs to the specified stop target RAID group is concatenated with a different RAID group using the LUN concatenation functionality, the disk is not stopped. To stop all related RAID group disks, execute the any one of the following methods. However, if the related RAID group is any of "Uncontrollable RAID groups", the disk control cannot be executed.
Specify all of the related RAID groups
Specify the -f option (The only storagadm spindle command can use this method)
Even if the target RAID group meets the conditions for the RAID group stopping, time more than a certain period is needed until the disk drive stops actually as described in the "Stopping disk drives". Please reconfirm the state after it passes for a while.
