Event traps are messages reported from a device. If you have any questions about the message contents, refer to the instruction manual for hardware to take corrective actions.
Depending on the event level, the corresponding icon may turn red (Error) or yellow (Warning).
(In case of the level "Information," the icon color is not changed.)
Failure event | Level | Event display |
|---|---|---|
Door open | Information | A library door has been opened |
Mail slot access | Information | A mail slot is being accessed |
Library error | Error | The library has posted a hard fault |
Slave error | Error | A slave module has faulted |
Cleaning cycle request | Information | One of the library tape drives has requested a cleaning cycle to ensure continued data reliability |
Fan error | Error | A tape drive fan has stalled |
Tape drive error | Error | A tape drive error has occurred |
Tape drive replacement | Warning | A tape drive has been removed from the library |
Slave replacement | Warning | A slave module has been removed from the library |
Load retry | Information | The library has detected excessive loader retries |
Explanation of the built-in LT130 bridge traps
Built-in bridge (FCO)
Failure event | Level | Event display |
|---|---|---|
Unit state change | Information, | Unit status changed: OK/Warning/Failed |
Unit event notification | Information | The unit trap message is output without any change. |
Unit sensor state change | Information, | Unit Sensor status changed: OK/Warning/Failed |
Unit port state change | Information | Unit Port state changed: online/offline/diagnostics |
Built-in bridge (FCO2)
Failure event | Level | Event display |
|---|---|---|
FCO temperature status change | Warning | The temperature status of FCO has changed. |
FCO voltage status change | Warning | The voltage status of FCO has changed. |
Online/offline status change | Warning | The online and offline status of the device has changed. |
