負荷分散／QoS制御 システム構築ガイド

1.8.3.1 運用側Traffic Director

hssetupコマンドにて設定を行います。入力箇所は強調文字で示してあります。

#/opt/FJSVnashs/bin/hssetup

Select hot standby mode.

1. Active

2. Standby

3. Not active

Please input : 1 [ENTER]

Select network monitoring.

1. Monitoring

2. No monitoring

Please input : 1 [ENTER]

Select primary interface used by the communication between duplicate node.

1. hme0

2. hme1

3. hme2

Please input : 2 [ENTER]

Select secondary interface used by the communication between duplicate node.

1. hme0

3. hme2

Please input : 3 [ENTER]

----------------------------

hme0 interface setup

----------------------------

Please set shared IP address.

Please input : 192.168.1.10 [ENTER]

Please set peer IP address.

Please input :[ENTER]

Please set polling IP address.

Please input : 192.168.1.1 [ENTER]

Please set IP address polled at the same time.

Please input : [ENTER]

Please set polling IP address.

Please input : [ENTER]

----------------------------

hme1 interface setup

----------------------------

Please set shared IP address.

Please input : 192.168.2.10 [ENTER]

Please set peer IP address.

Please input : 192.168.2.3 [ENTER]

Please set polling IP address.

Please input : 192.168.2.254 [ENTER]

Please set IP address polled at the same time.

Please input : [ENTER]

Please set polling IP address.

Please input : [ENTER]

----------------------------

hme2 interface setup

----------------------------

Please set shared IP address.

Please input : [ENTER]

Please set peer IP address.

Please input : 192.168.3.3 [ENTER]

Please set polling IP address.

Please input : [ENTER]

#