Enhanced Support Facility 2.6 User's Guide

3.11 rciopecall(1M)

NAME

rciopecall - Reports operator call on units connected via RCI

SYNOPSIS

/opt/FJSVhwr/sbin/rciopecall address {disp | on callNo | off callNo}

AVAILABILITY

FJSVscu, FJSVpscu, FJSVscu1, FJSVscu2, FJSVscu3

DESCRIPTION

rciopecall reports operator call on units connected via RCI.

The following models can use this command.

• GP7000F model 200/200R/400/400A/400R/600/600R/1000/2000
• PRIMEPOWER 200/250/400/450/600/650/800/850/900/1000/1500/2000/2500/HPC2500

OPTIONS

The following options are available:

address

Specifies addresses of units connected via RCI. Addresses are given in 8-digit hexadecimal.

You can specify the following value for action.

disp

Displays the operator call

on

Sets the operator call ON

off

Sets the operator call OFF

callNo

If "on" or "off" is specified for action, specifies callNo that controls the operator call. callNo is given in 2-digit hexadecimal.
callNo is set up only in the device that "1" is specified in bit by the ON/OFF designation. It is possible that more than one bit is specified at the same time.

EXAMPLES

# rciopecall 000101ff on 0c

# rciopecall 000101ff off 0c

# rciopecall 000101ff disp
address:000101ff  callNo:0c  status:00

NOTES

Note that only the super user can execute this command.

This status code returns the following values:

00	Meaning	Ended normally
20	Meaning	Not support on the specified node
	Action	Check the RCI address.
40	Meaning	Command Timeout
	Action	Check the RCI address, and retry to the command.

EXIT STATUS

This command returns the following values:

0

Ended normally

>0

Error