B.7.4 Configuring virtual interfaces with tagged VLAN (asynchronized switching)

PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Solaris(TM) Operating System)

Contents Index

Appendix B Examples of configuring system environments

> B.7 Example of configuring NIC switching mode (IPv6)

B.7.4 Configuring virtual interfaces with tagged VLAN (asynchronized switching)

This section describes an example configuration procedure of the network shown in the diagram below.

The xx, yy in the figure below are assigned automatically by the automatic address configuration.

If the Standby patrol monitoring function is not used, omit 4) in the procedure for setting up on each host.

An example of configuring /etc/inet/ndpd.conf to use Solaris server as an IPv6 router is described below:
For details on /etc/inet/ndpd.conf, refer to the Solaris manual.

ifdefault AdvSendAdvertisements true  # Every interface sends a router advertisement.
prefix fec0:1::0/64 fjgi1000          # fjgi1000 sends Prefix "fec0:1::0/64".
prefix fec0:2::0/64 fjgi2001          # fjgi2001 sends Prefix "fec0:2::0/64".

[HOST-A]

1) Setting up the system

1-1) Create /etc/hostname6.fjgi1000 and /etc/hostname6.fjgi2001 file as an empty file.

1-2) Define IP addresses and hostnames in /etc/inet/ipnodes file.

fec0:1::1       v6hosta1   # HOST-A Virtual IP(1)
fec0:2::1       v6hosta2   # HOST-A Virtual IP(2)
fec0:1::2       v6hostb1   # HOST-B Virtual IP(1)
fec0:2::2       v6hostB2   # HOST-B Virtual IP(2)
fec0:1::100     swhub1     # Switch/HUB1 IP
fec0:2::100     swhub2     # Switch/HUB2 IP

2) Creation of virtual interface

/opt/FJSVhanet/usr/sbin/hanetconfig create inet6 -n sha0 -m d -i fec0:1::1/64 -t fjgi1000,fjgi1001
/opt/FJSVhanet/usr/sbin/hanetconfig create inet6 -n sha1 -m d -i fec0:2::1/64 -t fjgi2001,fjgi2000

3) Setting up the HUB monitoring function

/opt/FJSVhanet/usr/sbin/hanetpoll create -n sha0 -p fec0:1::100 -b off
/opt/FJSVhanet/usr/sbin/hanetpoll create -n sha1 -p fec0:2::100 -b off

4) Setting up the Standby patrol monitoring function

Please define only one Standby patrol monitoring function.

/opt/FJSVhanet/usr/sbin/hanetconfig create -n sha2 -m p -a 02:00:00:00:00:01 -t sha0

5) Reboot

Run the following command to reboot the system. Make sure fjgi1000 and fjgi2001 are enabled as IPv6 interfaces after rebooting the system.

/usr/sbin/shutdown -y -i6 -g0

[HOST-B]