PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Solaris(TM) Operating System)

B.7 Example of configuring NIC switching mode (IPv6)

When using IPv6 address, it is required to set an IPv6 router on the same network. Also, specify the same prefix and prefix length of IPv6 address for redundant control line function configured in the IPv6 router.

---

B.7.1 Example of the Single system without NIC sharing

B.7.2 Example of the Single system with NIC sharing

B.7.3 Configuring virtual interfaces with tagged VLAN (synchronized switching)

B.7.4 Configuring virtual interfaces with tagged VLAN (asynchronized switching)

B.7.5 Network configuration in the Solaris container (logical IP takeover)

B.7.6 Example of the Cluster system (1:1 Standby)

B.7.7 Example of the Cluster system (Mutual standby) without NIC sharing

B.7.8 Example of the Cluster system (Mutual standby) with NIC sharing

B.7.9 Example of the Cluster system (Cascade)