PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Solaris(TM) Operating System)
Contents Index PreviousNext
Chapter 3 Environment configuration> 3.3 Additional system setup

3.3.5 GS/SURE linkage mode

The following shows the procedure for adding configuration information for GS/SURE linkage mode:

  1. Set up a virtual interface using the "hanetconfig create" command. For information, see Section "7.1 hanetconfig Command".
  2. Set up the remote party monitoring function using the "hanetobserv create" command. For information, see Section "7.5 hanetobserv Command".
    To change the monitoring period or number of monitoring times of this remote party, use "hanetpoll on" command. Refer to "7.7 hanetpoll Command" for details.
Contents Index PreviousNext
All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005