PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment)
Contents PreviousNext

Appendix B Line Monitoring Daemon

B.3 Adding/Deleting the Communication Path

Since a device name of NICs and an IP address of switches to monitor are changed when a communication path is added or deleted, it is necessary to update the internal information of the Line Monitoring Daemon.
This section describes the procedure required to add and delete the communication path dynamically.
  1. Adding or Deleting the Communication Path

    By using the Multipath common command, iompadm command, add or delete the communication path.

    Please refer to "8.2.2.3 Addition Procedure" or "8.2.2.4 Deletion Procedure" about addition or deletion of a communication path.


  2. Update the configuration file

    Please update the "/etc/opt/FJSVmpnet/conf/switch.conf" file about the logical device name of the communication path added or deleted, and the IP address of the switch connected to the NIC. Please refer to "B.2.2 /etc/opt/FJSVmpnet/conf/switch.conf" for details.


  3. Update the internal information of the Line Monitoring Daemon

    Please execute the following command, in order to update the internal information of the Line Monitoring Daemon to the information which procedure 2 defined.

    image

    Please refer to "B.3.1 mpnetudtbl command" about the details of this command.


DownB.3.1 mpnetudtbl command

Contents PreviousNext

All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005