PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment) |
Contents
![]() ![]() |
Chapter 8 Dynamic Reconfiguration Function | > 8.2 PCI Hot Plug function | > 8.2.2 The Procedure of the PCI Hot Plug function |
The procedure for incorporating a PCI card extended newly to the Multipath Function is shown in "Figure 8.4 Addition Procedure."
[Figure 8.4 Addition Procedure]
![]()
- The extension of the ATM cards is not supported.
- A different device from the media type of the device, which constitutes the MPNET interface, cannot be extended.
- Attach a PCI card
A PCI card to extend is incorporated by using the cfgadm command.
- Add a device to the Multipath Function
In order to add the attached PCI card to the Multipath Function, it changes to "stop" state by using the add subcommand of the iompadm command. Please refer to "6.3.2.9 add subcommand" about the add subcommand.
- Change to online state
The target communication path, which changed to "stop" state, is changed to "active" state or "standby" state by using the start subcommand of the iompadm command. Please refer to "6.3.2.6 start subcommand" about the start subcommand.
Contents
![]() ![]() |