PRIMECLUSTER Installation and Administration Guide 4.1 (for Solaris(TM) Operating System)
Contents Index PreviousNext
Part 4 System Configuration Modification> Chapter 8 Changing the Operation Configuration

8.1 Changing the Cluster Configuration

This section explains the following cluster configuration modification methods:

  1. Change a cluster application configuration.
  2. Change an operation attribute of a cluster application.
  3. Change a resource.

Be sure to stop RMS before changing the cluster configuration. If you start the "userApplication Configuration Wizard" screen while RMS is running, the message 0833 will be displayed. If this happens, stop RMS, and then restart the "userApplication Configuration Wizard" screen. For instructions on stopping RMS, see "Stopping RMS."

After you finish changing the cluster application, execute "RMS startup" from the Cluster Admin screen. If necessary, also start the cluster application. For instructions on starting RMS, see "Starting RMS." For instructions on starting the cluster application, see "Starting a Cluster Application."
Down8.1.1 Changing the Cluster Application Configuration
Down8.1.2 Changing the Operation Attributes of a Cluster Application
Down8.1.3 Changing Resources
Contents Index PreviousNext
All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005