The configurations of copy groups can be changed by adding or deleting copy pairs to or from AdvancedCopy Manager CCM.
Use the following procedures to change the configuration of copy groups.
Adding Copy Pairs
Add copy pairs to the ETERNUS Disk storage system that has been set up with AdvancedCopy Manager CCM. Add copy pairs by referring to "2.7 Adding Copy Pairs".
Deleting Copy Pairs
Delete the copy pairs for the ETERNUS Disk storage system that has been set up with AdvancedCopy Manager CCM.
Use the following procedure to delete copy pairs:
Stop Advanced Copies
Use one of the following commands (depending on the type of Advanced Copy) to stop all of the Advanced Copies that are executing for the copy pairs to be deleted.
acopc cancel command
acsnap cancel command
acec cancel command
Check the status of copy pairs
Use one of the following commands (depending on the type of Advanced Copy) to check that all of the Advanced Copies that are executing for the copy pairs to be deleted have stopped.
acopc query command
acsnap query command
acec query command
Delete copy pairs
Execute the acpair remove command to delete the copy pairs.
Information
If copy pairs have been deleted by mistake:
If a copy pair has been deleted by mistake, take one the following actions:
Use ETERNUS Web GUI to stop the Advanced Copy for the copy pair.
Add the same copy pair again, and then stop the Advanced Copy.
