PRIMECLUSTER Installation and Administration Guide4.6 Cloud Services

23.1.2 Changing Profile of AWS Command Line Interface

This section describes how to change the profile of the AWS Command Line Interface.

1. Execute the following command on any one of the nodes in the cluster system to stop RMS.

   # hvshut -a

2. Execute the following command on all nodes to stop the shutdown facility.

   # sdtool -e

3. Follow the procedures of the AWS Command Line Interface to set the profile on all nodes.

4. Modify the configuration definition file of the AWS shutdown agent on all nodes.

   For the description of the configuration definition file, refer to step 2 in "21.9.1.2.1 Setup Procedure of the Shutdown Facility for the Asynchronous Forcible Stop Method."

5. Modify the definition file for controlling network devices of AWS on all nodes.

   For the description of the definition file, refer to "21.10.1.1 Creating Definition File."

6. Execute the following command on all nodes to start the shutdown facility.

   # sdtool -b

7. Execute the following command on all nodes and make sure that the shutdown facility operates normally.

   # sdtool -s

8. Execute the following command on any one of the nodes in the cluster system to start RMS.

   # hvcm -a

9. Execute the following command on any one of the nodes in the cluster system and make sure that RMS operates normally.

   If RMS is stopped, "RMS is not running" is output.

   # hvdisp -a