PRIMECLUSTER Installation and Administration Guide4.6 Cloud Services

23.1.1 Configuration Information of AWS Command Line Interface and Changing Credentials

This section describes how to change the configuration information of the AWS Command Line Interface (such as region name) and credentials (access key and secret key).

1. Execute the following command on any one of the nodes in the cluster system to stop RMS.

   # hvshut -a

2. Execute the following command on all nodes to stop the shutdown facility.

   # sdtool -e

3. Follow the procedures of the AWS Command Line Interface to change the configuration information and credentials.

4. Execute the following command on all nodes to start the shutdown facility.

   # sdtool -b

5. Execute the following command on all nodes and make sure that the shutdown facility operates normally.

   # sdtool -s

6. Execute the following command on any one of the nodes in the cluster system to start RMS.

   # hvcm -a

7. Execute the following command on any one of the nodes in the cluster system and make sure that RMS operates normally.

   If RMS is stopped, "RMS is not running" is output.

   # hvdisp -a