The following are the incompatible functions of Redundant Line Control function from the previous version.
(1) Ping response monitoring in HUB monitoring function
[Contents 1]
The setting to disable ping response monitoring is possible.
[Changes 1]
Before modification
Ping response monitoring is always used.
After modification
The setting to disable ping response monitoring is possible.
[Contents 2]
It is possible to use ping response monitoring to multiple monitoring destinations from virtual interface of a single physical interface configuration.
[Changes 2]
Before modification
It is impossible to use ping response monitoring to multiple monitoring destinations from virtual interface of a single physical interface configuration.
After modification
It is possible to use ping response monitoring to multiple monitoring destinations from virtual interface of a single physical interface configuration.
(2) Link status monitoring in HUB monitoring function
[Contents]
Default of link status monitoring in the HUB monitoring function has been enabled.
[Changes]
Before modification
The link status monitoring function is disabled by default and link down of the NIC is not detected.
After modification
The link status monitoring function is enabled by default and link down of the NIC is detected.
(3) MAC address broadcast of IPv6 address
[Contents]
MAC address of the interface that activated the IPv6 address is informed in the following switching:
Route switching of NIC switching mode
Node switching of cluster configuration
Switching of transfer route is informed by MAC address broadcast.
[Changes]
Before modification
MAC address is not informed in switching.
After modification
MAC address is informed in switching.
(4) Detection time of driver hang in self-checking function
[Contents]
The driver hang up detection time for the self-checking function is set to 60 seconds.
[Changes]
Before modification
The initial value for the driver hang up time for the self-checking function is 15 seconds.
After modification
The initial value for the driver hang up time for the self-checking function is 60 seconds.
