The following are the incompatible commands of Redundant Line Control function from the previous version.
(1) strhanet command/hanetnic add command
[Contents]
Under the following conditions, these commands end with an error when GLS bundles the physical interfaces that are already used by other interfaces except GLS.
Redundant line switching mode is Virtual NIC mode, and
OS is RHEL7, and
Target physical interfaces are already used by other virtual interfaces (bonding, virtual bridge, for example) except GLS.
The configurations described above have not been supported from previous versions. Therefore, the supported configurations are unchanged in this version.
[Changes]
Before modification
The command ends successfully. However, the target physical interfaces cannot be used for communication.
After modification
The following error message is output and the physical interfaces cannot be bundled.
ERROR: 923XX: physical interface is already linked by another network device. (shaX:ethY) |
(2) hanetconfig command/hanetpoll command
[Contents]
In single user mode, the configuration definition of NIC switching mode can be added, changed, and deleted.
[Changes]
Before modification
When the system is started in single user mode, the configuration definition of NIC switching mode cannot be added, changed, and deleted.
After modification
If the system is started in single user mode, the configuration definition of NIC switching mode can be added, changed, and deleted.
[Contents]
The default value of "-e" option is changed from "NO" to "YES". For details, see "7.6 hanetparam Command."
[Changes]
Before modification
For the default value of "-e" option, "NO" (self-checking function is disabled) is set.
After modification
For the default value of "-e" option, "YES" (self-checking function is enabled) is set.
[Notes]
When the product version is upgraded, this setting is taken over.
