Synopsis
[To set/change] jobschcod day change time [-sys subsystem number] [To cancel] jobschcod -off -sys subsystem number
Description
The jobschcod command changes the day change time.
Options
day change time
The day change time is set. Specify this option in the format "hhmm" in four digits. "hh" is set in a range "from 00 to 23" (hour) and "mm" is set in a range "from 00 to 59" (minute).
Example Setting
The following shows an example where the day change time is set to 9.05 a.m.
jobschcod 0905
-sys subsystem number
Specifies the target subsystem in a system that is operating multiple subsystems. Specify a subsystem number from 0 to 9. If you omit this option when setting or changing the day change time, the command will apply to the system day change time.
-off
Cancels the day change time setting for the specified subsystem number.
Command Location
Windows | Systemwalker Operation Manager installation directory\MpWalker.JM\bin |
Solaris | /usr/bin |
Privilege Required
System administrator (user belonging to the Administrator group or superuser) privileges are required.
Cautions
The day change time can be changed only by a system administrator (user belonging to the Administrator group or superuser). General users cannot use the jobschcod command.
The system day change time is stored in SYSTEM_CALENDAR. You should be aware of when using the jobschcod command because the power schedule will be also affected, not only the schedule of Jobscheduler (except for HP-UX, AIX).
