This chapter describes the Jobscheduler commands provided by Systemwalker Operation Manager. Note that the commands must be executed on the server where the Systemwalker Operation Manager server function is installed. For the Jobscheduler commands that are used to output information, see Chapter 5 Jobscheduler Commands (For Printing).
Note
If commands are executed in an environment where the UAC function has been enabled, then a dialog box asking a user's privileges to be promoted may be displayed depending on the privileges of the user that logged in to the operating system, and action may be required.
Refer to "Notes on Executing Commands in Windows [Windows version]" in the Systemwalker Operation Manager User's Guide for more information.
Note
Notes when you execute Jobscheduler commands
When executing a command, make sure the following conditions are satisfied:
The Jobscheduler service/daemon must be running (the jobschconvert command is not this case).
The standard output and standard error output should not be closed.
The system resource availability (maximum file size limit) for respective user should not be limited by the user who executes the command. (Otherwise, the command may not be executed correctly. Additionally, the maximum file size limit may cause the schedule information file to be damaged.) [UNIX]
The commands can be executed by a user who is already logged on to the Windows server/UNIX server.
