If CF is stopped on the initial connection node, the Cluster Admin main window appears with the CF options of Load driver or Unconfigure (see below.) The CF state must be UNLOADED or LOADED to start CF on a node.
Figure 4.14 CF configured but not loaded
Click on the Load driver button to start the CF driver with the existing configuration.
The Start CF services popup appears (see below.) By default all CF services that have been installed on that node are selected to be started. The contents of this list may vary according to the installed products.
Figure 4.15 Start CF services pop-up
You may exclude CF services from startup by clicking on the selection check box for each service that you do not want to start. This should be done by experts only.
Click on the Ok button and a status popup appears with the results of each service start operation (see below.)
Figure 4.16 Start CF services status window
Click on [OK] to return to the Cluster Admin main window, after all the service startup has finished.
If [Cancel] is clicked, the startup process of the inactivated CF service is canceled.
The already activated CF service will remain in an activated state.
