All users using the Web-Based Admin View
Set the operation environment for the Web-Based Admin View as described below.
Point
For reference or setup of operation environment, there are two methods; one is to execute a command directly on each management server and monitoring node, and the other is on an environment settings screen. The latter one is explained below.
Normally, when the setup is modified on the environment settings screen, all monitoring nodes should be activated, and are connected to the primary management server as well. If there's an inactive monitoring node or node which is not monitored by the primary management server, refer to "4.5 Reference and modification by command" and set up as required on each node.
There are the following three kinds of functions with the environment settings screen. Each screen is displayed by selecting a tab.
User environment
System environment
Node environment
The following usage varies according to each function.
User environment | System environment | Node environment | |
|---|---|---|---|
Use | Set tentative operating conditions | Determine the operating conditions of the entire system | Specific setting for each monitoring node |
Target user | All users | The root user or the user that belongs to the Web-Based Admin View administrator group (wvroot) [*1] | |
Setup timing | As long as the Web-Based Admin View is active. | ||
Setup validation timing [*2] | [End] -> 0052 message : select [Yes] -> The value is validated right. | [End] -> 0051 message : select [Yes] -> 0015 message : select [OK] -> Log off [*3] -> { Web-Based Admin View running on the management server restarts automatically } -> 0003 message : the value is validated. | [End] -> 0059 message : select [Yes] -> 0015 message : select [OK] -> Log off [*3] -> { Web-Based Admin View running on the management server restarts automatically } -> 0003 message : the value is validated. |
[*1] The user who logs in by authority of other user group, except administrator group (wvroot), cannot set the system environment and the node environment because the tabs for those environments are not displayed.
[*2] Below explains the operation procedure from selecting [End] in the environment settings screen to validating of setting value.
00xx : Indicates the number of a displayed message.
[*3] Be sure to log off all clients connecting to the management server. Web-Based Admin View waits until all clients are logged off, and then restarts automatically. When selecting [Yes] to 0051 or 0059 message, 0015 message is displayed on all clients. Be sure to log off all clients.
When any client is logged in, Web-Based Admin View is started up again automatically if certain amount of time (10 minutes) passes. So the logged-in clients must be logged off, and then 0007 message is displayed.
Note
Please select [Cancel] if the operating environment setting is ended without any changes for settings.
